What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 20.06.2025 00:35

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–10[John johnson John Johnson ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Are there any industries or sectors where ChatGPT is particularly well-suited for implementation?
What does a fuse do?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
The administration’s anti-consensus Mars plan will fail - SpaceNews
At one ohm, the resistor has a maximum of 1 watt power.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
What would have happened if Shin was a good movie instead of a bad one?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where this question deviates from being a 'generic' question, and becomes more specific.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
For this case there are devices called Metal oxide varistors (MOV).
But… the neutral is now “floating” because of the 1 ohm resistance.
Are rich people harder workers than poor people as a whole?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
(Dc diagram shown, AC is similar).
He then describes Rainy Season and Lightning.
These are simplified answers to the original question, and does not change anything I wrote above.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
There are three different concepts here that are getting confused.
Is LGBTQ destroying the world?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This device then solves the entire problem.
Now when you have a certain ac resistance, then a current flows in a loop.
In schematic diagrams this is the symbol for a fuse:
Why don't some people like the 10 Commandments?
a photo is worth a thousand words.
This one hit behind the barn.
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
These devices are installed between the “hot” and “neutral” and protective ground.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Barnstars:
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
I post the exact comment here.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
An AC voltage/ current source, and an ac inductive load.
But it can get overloaded, and no longer works.
At least they know the answer if they wanted it.
A fuse is a non-resetable over current circuit protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
First Sentence:
but this device (an Inductor) … impedes the rapid changes in the current.
the problem then depends on "how fast does the fuse operate?".
What is lightning?
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–14 [Omar Gharbi Omar Gharbi ]
Upvotes:
One
eight
The bolt then partially travels down the line to your home.
There are two important concepts here.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Edit 2024–10.
[image of Common-mode choke]
[old diagram got deleted by accident]
so, what happens?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
what exactly is a ‘surge’ protector?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It seems Mohan does not understand the difference between a comment and an Answer.
nine
He then describes the function of a fuse.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The other is “what does a “fuse” do?”
He then asserts :
It also is a device that limits the change in current flow.
The third is lightning and “how it gets conducted into a home.”
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where the MOV conducts again, and dissipated the energy.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
This is 'the assistant's answer'
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
A circuit breaker is similar, but is resettable.